Configure a Pipeline run to a particular Node

dpan32 - I understand what you are saying but I don't see the benefit.  Why not allow the snaplex to load balance and give any of those jobs the most resources available?  If you really want to split your jobs that way, you could create two snaplexes: one for triggered tasks and one for scheduled.   But in either of those cases, you lose the redundancy that the 2 node plex gives you.

dpan32 - can you explain your use case why you want to run on a specific node in the plex?  SnapLogic will allocate to the "most free" node in a snaplex when you start the pipeline.

Hi koryknick Suppose a scenario occur where I need to run a ultra pipeline in groundplex. In this case I must run the particular pipeline in feedmaster node. If the particular Groundplex have two node one is Jcc and other is feed master I need to configure such way that my ultra pipeline always run on the feed master node. Is there any specific way to do that.
I was thinking one of the solution to create a particular ground plex with only one feed master node and use that plex for the ultra pipeline only. please let me know if this solution is convenient or there is any better approach to achieve this scenario

dpan32 - please review the documentation for FeedMaster nodes. The FeedMaster does not run pipelines - it only acts as an interface between the caller and the execution nodes.  If you have further questions on snaplex configuration, please contact your SnapLogic CSM.