Workday Snap and Proxy Configuration
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2018 04:33 AM
Hi, we are doing some testing of the Workday Snap and sit behind a Proxy and it is not working. We are using a GroundPlex and have configured the proxy settings to navigate through the proxy. I’ve validated the Proxy is working by using other Snap’s to connect and can see in the logs it successfully traverses the proxy. However, with the Workday Snap, it does not seem to be attempting to go through the proxy at all. I’ve been able to prove this by doing a tcpdump. I even went as far to create a brand new Snaplex in a different AWS account, configure it and NOT put a proxy and the pipeline executes fine. What am I missing? Any suggestions on what to check?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2018 09:37 PM
Have you tried following these instructions and troubleshooting steps?
